S/N Ratio (A Weighting): 85 dB (MM) / 74 dB (MC) Input Impedance: 47KΩ (MM) / 1KΩ (MC) Output Impedance: 100 Ω (MM) / 100 Ω (MC) Channel Balance: 2 dB(MM) / 2 dB(MC) Distortion (5mV input): <0.015% (MM) / <0.015%(MC) Gain (1 KHz): 40 dB(MM)/ 55 dB (MC) RIAA Accuracy: ± 2 dB(MM) / ± 2 dB(MC) Max Input: 5 mV (MM) / 0.5 mV (MC) Max Output: 600 mV(MM) / 200 mV(MC) Sensitivity: 110(MM) / 370(MC)
輸入阻抗: 47KΩ(MM) /1KΩ(MC)
輸出阻抗: 110Ω
The Blackline PH2 is a high performance
phono-pre-amplifier that supports both
moving coil and moving magnet cartridges. Although some amplifiers have an integral
phono stage, PH2 is a dedicated phono
pre-amplifier that offers an audible sound
upgrade once connected between your
Turntable and Amplifier. PH2 can easily fit into any existing audio
system where a phono stage is required. Even if your existing amplifier has a built
in phono stage, PH2 can be connected to
Line In and will offer an improved
performance as most built in phono
stages are not of high quality. A new addition to our Blackline range,
PH2 sits between your amplifier and
Turntable and can be switched between
moving coil and moving magnet cartridges. Fundamentally, moving magnet cartridges
have a higher level of amplification compared
to moving coil type. The phono stage increases
the signal level from the turntable cartridge
to the amplifier. PH2 will provide a sound
improvement over traditional inbuilt phono
pre-amplifiers.
phono-pre-amplifier that supports both
moving coil and moving magnet cartridges.
phono stage, PH2 is a dedicated phono
pre-amplifier that offers an audible sound
upgrade once connected between your
Turntable and Amplifier.
system where a phono stage is required.
in phono stage, PH2 can be connected to
Line In and will offer an improved
performance as most built in phono
stages are not of high quality.
PH2 sits between your amplifier and
Turntable and can be switched between
moving coil and moving magnet cartridges.
have a higher level of amplification compared
to moving coil type. The phono stage increases
the signal level from the turntable cartridge
to the amplifier. PH2 will provide a sound
improvement over traditional inbuilt phono
pre-amplifiers.